User Manual

20
Setup Examples
Several setup congurations are possible with your Powercab or
Powercab Plus system(s)�
• Connect your modeler's analog 1/4" or XLR mono output to the
Powercab input, or your modeler's stereo analog outputs each to
a separate Powercab input�
• If using an "amp-in-the-box" type and/or eects pedals, connect
them into to the Powercab with a 1/4" audio cable�
• Connect digitally via L6 LINK or AES/EBU to one or two Powercab
Plus systems (see "L6 LINK" on page 23)�
• To use a remote MIDI controller device, connect it to the Powercab
Plus MIDI IN ("MIDI" on page 24)�
• Send a direct signal to a P�A� or mixer using the Powercab analog
XLR Output�
• Optionally, you can use the Powercab Plus combo Input 2 to
receive a monitor feed from a mixer, or as a USB audio interface
to process your guitar signal on a computer and listen through
Powercab�
FXFX
PREAMP
FXFX
PREAMP
Direct out to
front-of-house
L6 LINK
or AES
Direct out to
front-of-house
Input 2 as monitor feed from a mixer
Analog
Analog
+ MIDI
Powercab 112 Analog Setup
FXFX
PREAMP
FXFX
PREAMP
Direct out to mixing board or
audio interface
1. Connect the 1/4" or XLR output from the modeler/processor to
the combo input on Powercab�
2. Optional: Connect an XLR cable to the output of Powercab to
send to a mixing board or recording interface� The output signal
will have an SM57 microphone model applied when using speaker
models�
+
Powercab 112 or 112 Plus Analog Stereo Setup
FXFX
PREAMP
Connect the left and right analog 1/4" or XLR outputs of your
modeler (or stereo eects unit) separately to two Powercab devices.