User Manual

19
+
+
GLOBAL SETTINGS
Name Value Range Default MIDI CC CC VALUE Function
Direct Out Level
Line
Mic
Mic Controls the output level of the XLR Direct Outs� Use Line
Level for nominal line inputs and use Mic Level when going
into the mic preamp of a mixing board or audio interface�
+
Direct Out
Mode
Mono
Stereo
Stereo Determines whether or not the Left/Mono XLR output is
merged to mono�
+
Stereo Width
% 0 – 200 100 CC 110 0-100
50 = 100%
100 = 200%
Collapses to mono at 0%, nominal at 100%, and extra
wide at 200%�
Auto Dim
O
5 seconds
10 seconds
30 seconds
O – 30 seconds 10
seconds
Selects how long the time out is before the Auto-Dim
feature activates for the LCD display and Select knob
LEDs�
Firmware Version
2�00�0 Displays the Powercab system's current rmware version
(x�xx�x)
Factory Reset Press SELECT and conrm to restore all factory presets
and global settings�
Input 2 Monitor Mode
This mode is intended for running a monitor feed, which may include
vocals or other instruments, from a mixing board back into Input 2 of
your Powercab Plus. This signal goes straight to the power amplier
system and does not loop back out to the XLR Output�
Input 2/Aux USB Mode
This mode is intended for the use of Powercab Plus as a traditional audio
interface� Plug your guitar or line level feed into Input 2 ("Right/Aux"
on Powercab 212 Plus) and you can use a DAW or audio software to
process your signal� For example, this mode could be for processing the
guitar signal with the Helix Native plug-in, which then plays back through
the Powercab Plus amplier and speaker(s). This could be done with or
without speaker/IR processing, depending on the Powercab Plus USB
Mode global setting� This method does add some round trip latency and
will depend on your computer processing power and buer settings.