User Manual

18
+
+
GLOBAL SETTINGS
Name Value Range Default MIDI CC CC VALUE Function
Input 2/R Mode
Normal
Monitor
USB
Normal CC 3 0-4 0: Normal
41-80: Monitor
81-127: USB
Normal: Processes input and routes signal through the XLR
Output�
Monitor: No processing is applied and the signal is not
rerouted to XLR Output�
USB: Input 2 is routed to the USB 1/2 input and can be
used with guitar amp modeling software like Helix Native�
Be sure to enable input monitoring in your DAW software
and arm the track for recording� Also see "Input 2 Monitor
Mode"�
Link Inputs
O
On
On CC 4 0-63: O
64-127: On
Selects whether or not both Input 1 & Input 2 Gain levels
are matched to the same value�
HF Trim
dB -96�00 to +12�00 0�0 CC 5 0-127
100 = 0�0dB
Gain adjustment for the high frequency compression driver�
+
Low Cut
O
On
O CC 111 0-63: O
64-127: On
Applies a global 80 Hz low cut (high pass lter) to speaker
output
MIDI Channel
# 1–16, Omni 1 Selects the MIDI channel to which the Powercab Plus
responds and transmits to the MIDI DIN (when MIDI Thru is
set to "On")�
MIDI Thru
O
On
On Determines whether or not incoming MIDI is passed
through the unit�
MIDI Receive
O
PC+CC
PC Only
CC Only
PC+CC Determines whether or not this unit changes presets
in response to incoming MIDI Program Change (PC)
messages, MIDI Control Change (CC) messages, both, or
neither�
MIDI Send
O
PC
PC Determines whether or not MIDI PC messages are
transmitted whenever a local PC change event occurs
(when a preset change is made on the unit)�
MIDI Over USB
O
On
O Determines whether or not MIDI data is received and sent
over USB�
USB Mode
Normal
Processed
Normal CC 6 0-63: Normal
64-127:
Processed
Normal: Use for playback directly to an FRFR system�
Processed: Processes the USB signal with Flat, Speaker, or
User IR modes�