User Manual

14
+
+
EDIT SETTINGS
Name Value Default MIDI
CC
CC VALUE Function
USER IR MODE
PARAMETERS
This mode allows for the use of a third-party cabinet simulation (Impulse Response) that reproduce the sound of a "miked"
cabinet. See "Impulse Responses" and "Powercab Edit Software"
IR (1)
IR location 0 – 127 0 CC 25 0 – 127 Selects which User IR is being applied
to Speaker 1� The selected IR's name is
displayed on the screen�
+
IR (2)
IR location 0 – 127 0 CC 105 0 – 127 Same Function as IR (1), but for
Speaker 2�
GENERAL PRESET
PARAMETERS
The following parameters are available regardless of which mode is selected within the preset.
Low Cut 1
O
20Hz – 500Hz
O CC 26 0 – 127 Tone too muddy or boomy? Apply the
Low Cut Filter to clean it up�
High Cut 1
O
500Hz – 20kHz
O CC 27 0 – 127 Guitar speakers typically roll o high
frequencies well below the range of a
full-range reproduction system� Tone too
harsh and unnatural? Apply the High Cut
Filter to reduce the higher frequencies�
+
Low Cut 2
O
20Hz – 500Hz
O CC 106 0 – 127 Same as Function as Low Cut 1, but for
Speaker 2�
+
High Cut 2
O
500Hz – 20kHz
O CC 107 0 – 127 Same as Function as High Cut 1, but for
Speaker 2�
Level 1
-60�0dB to +6�0dB 0�0dB
(Flat
Mode)
-15�0dB
(Speaker)
-18�0dB
(User IR)
CC 28 0 – 127 Controls the volume of the current preset
and can be adjusted to match levels
between presets� When an IR is in use,
the default is -18�0dB to compensate for
the higher amplitude common to IR les.
When the Flat Mode is in use, this is set
to 0�0dB for maximum headroom�