User Manual

26
`
6 Switch Looper
1. Add a 6 Switch Looper block to your preset.
2. Press the Looper assigned footswitch to open Looper mode:
BA
DC
1
16C Two–Plus Decades
OverdubPlayback Low Cut High Cut
UNDO
1/2 FULL
REV FWD
ONCE
SPEED
Switch Description
Step on to start recording a loop. Step on to end the loop and
immediately start playback. Step on to overdub additional parts. Step
on again to stop playback.
If you make a mistake on your last overdub, step on UNDO to erase it.
Step on to play the recorded loop once through.
Recording at full speed and then switching to 1/2 speed will also drop
the loop down one octave. Recording at 1/2 speed will double your
looping memory, and switching to full speed will cause the loop to play
at double speed (up an octave).
Step on REV/FWD to hear your loop backwards.
3. When nished, press MODE/EDIT/EXIT.
NOTE: If you press while loop playback is stopped, this will always record a
new loop, and any previous recording will be discarded.
IMPORTANT! You may change presets while looping, but loop playback will
stop unless the preset you select includes the same type of looper block.
1 Switch Looper
1. Add a 1 Switch Looper block to your preset.
2. Press the Looper switch.
The LED lights red, indicating the loop is recording.
3. Press the Looper switch again.
The LED lights green, indicating the loop is playing back.
4. Press the Looper switch again.
The LED lights amber, indicating the loop is in overdub mode. Subsequent presses
of the switch toggle between play and overdub mode.
5. While the Looper is in play or overdub mode, press and hold the
switch for 1 second.
The most recent recording is undone. Holding the switch again will redo the
recording.
6. Quickly double-press the Looper switch.
Playback/recording stops and the LED lights white, indicating a loop is in memory.
7. While Looper playback/recording is stopped, press and hold the
switch.
The recording is deleted and the LED lights dim white.
IMPORTANT! You may change presets while looping, but loop playback will
stop unless the preset you select includes the same type of looper block.