User Manual

25
Parameter Description
Decay
Setsthelengthoftimethereverbeectsustains.
Predelay
Determinespredelay—orthetimebeforethereverbeectisheard.
Spread
Spreaddiersslightlyamongstereodelayeects.Formostdelays,
itadjustshowwidelytherepeatsbounceleftandright.Forexample,
with the Ping Pong Delay, 0 is in the middle (mono), and 10 is full left
to right panning for the repeats.
Formodulatedstereodelays,SpreadaectstheLFOs’(lowfrequency
oscillators) stereo modulation behavior. At 0, the LFOs are in sync. At
10, the two LFOs are 180 degrees out of sync, so that when one side
is modulating up, the other side is modulating down.
Headroom
Somemodanddelaypedals’internalsignalpathsexhibitabitofgrit,
especially when placed after a high-gain distortion block. Negative
values increase the perceived amount of grit; positive values clean
things up a bit. At 0dB, the model behaves like the original pedal.
Low Cut
Filters a portion of the block’s bass and/or treble frequencies, which
can help remove rumble and/or high-end harshness.
High Cut
Mix
Blendstheeected“wet”signalvs.the“dry”signalpassedthrough
theblock.Whensetto0%,thepathbypassestheeectcompletely.
Whensetto100%,theentirepathisfedthroughtheeect,andno
dry thru signal is heard.
Level
Adjuststheoveralloutputleveloftheeectsblock.Becarefulnotto
boost this parameter too high on multiple blocks, as digital clipping
could occur. You should typically leave this at 0.0dB for most blocks.
Where the original pedal’s level or volume knob behavior doesn’t really
apply to dB values, 0.0-10 may be used.
Trails
Trails O: Any delay repeats or reverb decays are instantly muted
when the block is bypassed. Trails On: Any delay repeats or reverb
decays continue to decay naturally when the block is bypassed, or a
dierentsnapshotisselected.
Looper
AsinglemonoorstereoLoopercanbeaddedasoneofthefoureectsblocks.
Looper Models (Mono or Stereo)
Model Based On*
6 Sw Mono Looper
Line 6 Original
1 Sw Mono Looper
Line 6 Original
6 Sw Stereo Looper
Line 6 Original
1 Sw Stereo Looper
Line 6 Original
Looper Type Max. Loop Length (Full Speed) Max. Loop Length (1/2 Speed)
Mono
40 seconds 80 seconds
Stereo
20 seconds 40 seconds
Looper Settings
Knob Parameter Description
1 Playback
Adjustslooperplaybacklevel.Youmaynditusefultoturn
this down a bit so your live guitar can be slightly louder.
2 Overdub
Relatively sets the level of your loop while overdubbing. For
example,ifyourOverdubLevelissetto90%,eachtimeyour
loop repeats, its volume will be reduced by 10%, sounding
quieter and quieter with each overdub pass.
3 Low Cut
Filters a portion of the loop’s bass and/or treble frequencies,
whichcanimprovethemixwithyourliveguitar.
4 High Cut