User Manual

10
IMPORTANT! The G10T transmitter’s LED lights green when powered on
and the battery has more than 30 minutes left. If the battery has less than 30
minutesleft,theLEDashesred.
Toextendbatterylife,sleepmodeisactivatedafteraperiodof4minuteswhereno
audio input is detected. The transmitter “wakes up” when the instrument is played.
Using Multiple POD Go Wireless Systems
Up to four POD Go Wireless and/or standalone Line 6 Relay wireless systems can be
used on the same stage. However, care should be taken to ensure all systems are set
up properly:
1. For the rst system, connect the G10T transmitter to the POD
Go Wireless GUITAR IN jack and wait 10 to 15 seconds.
Make sure the transmitter’s LED lights green.
2. Connect the transmitter to your guitar’s output.
3. Before the rst transmitter goes to sleep (after 4 minutes of no
audio input), repeat the above steps 1 and 2 for any additional
POD Go Wireless systems.
Each system’s scanning procedure works around other active wireless channels
to help ensure high quality performance for all systems.