Micro Spider ® Pilot’s Guide Manuel de pilotage Pilotenhandbuch Pilotenhandboek Manual del Piloto 40-00-0166 Electrophonic Limited Edition available @ www.line6.
All product names referred to in this manual are trademarks of their respective owners, which are in no way associated or affiliated with Line 6. These trademarks of other manufacturers are used solely to identify the products of those manufacturers whose tones and sounds were studied during Line 6’s sound model development.
Line 6 and Micro Spider are trademarks of Line 6, Inc. All other product names, trademarks, and artists’ names are the property of their respective owners, which are in no way associated or affiliated with Line 6. Product names, images, song names and artists’ names are used solely to identify the products whose tones and sounds were studied during Line 6’s sound model development for this product.
You should read these Important Safety Instructions. Keep these instructions in a safe place. Before using your Micro Spider, carefully read the applicable items of these operating instructions and the safety suggestions. 1. Obey all warnings on the amp and in the Micro Spider Manual. 2. Connect only to AC power outlets rated 100-120V or 200-240V 47-63Hz (depending on voltage range of the unit; refer to back panel). 3. Do not perform service operations beyond those described in the Micro Spider Manual.
Power Flip the switch on when you're ready to rock out. Power down between sessions for maximum battery life! P X - 2 Powe r S u p p l y I n p u t Only use a Line 6 PX-2 power supply when powering your Micro Spider using the AC IN connection. Strap Buttons Attach the included nylon strap here. Also allows most standard guitar straps to be used. AC IN POWER Power Requirements: 9VAC 2000 mA minimum Load Batteries You'll get up to 20 hours of power with 6 C sized batteries.
Plug In Here The front panel Amp Model and tone controls, plus the top panel effects, all apply to the guitar that’s connected here. Channel Memories / Amp Models The five channels each use a different Amp Model, and all come pre-loaded with a factory preset dialed in to nail a great tone. Press one of these buttons to hear the presets. To replace any preset with your own “snapshot” of all tone and effect knob positions (except Master Volume), press and hold one of these four buttons for two seconds.
Mic In Connect a microphone here to sing along with your guitar or use the amp as a small P.A. system. CD/MP3 (IN) Connect your CD or MP3 player here to hear and play along with your music collection. Phones/Record Out Listen with headphones, or use this as a POD quality direct out for recording!(The speaker is muted when this jack is in use). TUNER Mic Trim Use this knob to adjust the volume of the mic.
Welcome The Micro Spider... Thank you for inviting Micro Spider home with you. This amp mines the tonal heritage of the past forty years of guitar amplifier design and matches it up with the kind of digital signal processing magic that will still be ahead of its time ten years from now—all in a battery powered package that goes anywhere.
Tap Button Extra Functions Special Hidden Functions The Tap button, in addition to setting the time of your echo effects, also lets you access a Distortion Boost and a built-in Noise Gate. When you select an Amp Model, Micro Spider automatically sets its tone controls and effects to match that Amp Model. You can disable the auto-FX selection (but not tone control auto-selection) by powering up Micro Spider with the INSANE Channel button held. The auto-selection will be re-enabled next time you power up.
Pilot's Log Get tone settings for a collection of great guitar songs from our web site, www.line6.com. Make a note of your favorite settings here by marking which channel is selected, the positions of the knobs, and the Tap tempo.