User Manual
19
Saving/Naming a Preset
1. Press SAVE to open the Save Preset screen:
Cancel Delete Insert
Replace 1 FACTORY 1 > 26A M’Lady Neckbeard
Setlist
1
Destination
26A
Save Preset
Save
M‘ Lady
Ne c
kbeard
L
N
O
P
J
K
Move the joystick left or right to move the cursor.
Turn the joystick (or move it up/down) to change the selected character.
Press Knob 2 (Delete) to delete the selected character and shift all following
characters to the left.
Press Knob 3 (Insert) to insert a space and shift all following characters to
the right.
SHORTCUT:PressthejoysticktocyclethroughA,a,0,and[SPACE].
2. Turn Knob 4 (Setlist) and Knob 5 (Destination) to choose the
Setlist and Preset location you wish to overwrite.
Any of the Helix 1,024 presets can be overwritten.
3. Press SAVE again or Knob 6 (Save).
Serial vs. Parallel Routing
Formanyguitartones,aserial(onestereopath)signalowismorethanadequate.
For example, our 8 TEMPLATES > 01A Quick Start preset has a volume pedal, wah
pedal, Amp+Cab, reverb, and looper, but there's still room for distortion, modulation,
and delay blocks:
Formoresophisticatedtones,aparallel(twostereopaths)signalowcanbecreated.
This lets one split the signal into two stereo paths, process them separately, and mix
the two paths back together.
1. Select the Amp+Cab block and press ACTION to pick it up.
2. Move the joystick down.
The Amp+Cab block is moved to a newly created parallel path B (lower).
In the illustration above:
Our guitar signal goes into the Volume and Wah blocks.
The signal is split to path 1A (upper) and path 1B (lower).
Stereo path 1A (upper) is sent to the Reverb and Looper blocks and Stereo path
1B (lower) is sent to the Amp+Cab block.
Stereo paths 1A and 1B are merged together after the Looper block and sent to
the Multi Output.
3. Press ACTION again to drop the Amp+Cab block.
This preset probably doesn't sound ideal. A more appropriate tone may have paths 1A
and 1B each with an Amp+Cab block, only to merge again before the Reverb...