User Manual

18
If Path 2 has two input blocks, you may select either Path 2A or 2B, or even split your
signal further to both 2A and 2B. See "2 into 1" for an example.
TIP: To view a list of available outputs, press the joystick.
Moving Blocks
1. Select any block (other than Input or Output) and press ACTION.
The block appears “picked up” and the action panel appears. The inspector's
icon shows you the directions in which the block can be moved.
Use joystick to move block; move down to create Path B
Clear
Block
Clear All
Blocks
Copy
Block
P
aste
Bl
oc
k
2. Move the joystick left or right to move the block.
Moving the joystick down moves the block to a new parallel B path. See "Serial
vs. Parallel Routing" for details.
NOTE: A block on Path 1 cannot be moved to Path 2 (and vice versa). You
can, however, copy and paste a block from one path to the other. See next
section.
3. Press ACTION again (or ) to close the action panel.
Copying and Pasting a Block
Blocks from one path can be copied and then pasted into the same path, the other
path,orapathinanentirelydierentpreset.
1. Select the block you wish to copy and press ACTION.
2. Press Knob 1 (Copy Block).
3. Select the location you wish to paste the block—even in a dif-
ferent preset—and press ACTION.
4. Press Knob 2 (Paste Block).
NOTE: Inputs, Outputs, Splits, Merges, and Loopers can also be copied and
pasted. However, if you, for example, try pasting the Looper into the Split
block's location, Knob 2 (Paste Block) will be grayed out. Furthermore, if the
destination path’s DSP cannot accommodate the copied block, the header
willbrieyread“CannotPaste—Path1[or2]DSPfull!”See"Dynamic DSP"
C
l
ear
B
l
oc
k
Clear All
Blocks
Copy
Bl
oc
k
Paste
Block
Cannot Paste—Path 1 DSP Full!
Clearing a Block
1. Select the block you wish to clear and press ACTION.
2. Press Knob 3 (Clear Block).
Clearing All Blocks
Clearing all blocks removes all processing blocks (including the Looper) and resets
bothPath1and2toserial.ItdoesnotaectPath1AorPath2AInputandOutput
blocks,nordoesitaectthe"Command Center"
1. Press ACTION.
2. Press Knob 4 (Clear All Blocks).
The following dialog appears:
OKCancel
Clear all blocks?
3. Press Knob 6 (OK).