User Manual
11
Quick Start
Connect Helix Rack and Helix Control
1. Using the CAT-5 cable (included with Helix Control), connect
Helix Rack's HELIX CONTROL port to Helix Control's HOST
port.
NOTE: Helix Control receives power from Helix Rack. Helix Control's DC IN
jack may be required for very long CAT-5 cable runs. In such case, use only
a Line 6 DC-3G power supply (purchased separately - see the Line 6 Store).
2. Turn on both Helix Rack and Helix Control.
IfHelix Controlisleftswitched on, you may switch both onandofromHelix
Rack's power switch.
Setting Proper Output Levels
1. Make sure the VOLUME and PHONES knobs are turned down.
PHONES
2. Connect a guitar to the Helix GUITAR IN jack.
3. Connect the Helix outputs to your playback system.
OR
The Helix 1/4” and XLR output levels must be set to match your playback system.
If you’re only using headphones for now, skip to step 9.
4. Press to open the Menu.
5. Press Knob 6 (Global Settings).
The Global Settings screen appears:
Ins/Outs
MIDI/T
emp
o
D
i
sp
l
ays
Footsw
i
tc
h
es
Global Settings
Pre
f
erences
EXP Pe
d
a
l
s
Firmware Version 2.00.0
Mic In
48V Phantom
Off0dBOff
Off
Mic In
Low Cut
Mic In
Gain
Guitar In
Pad
Ins/Outs
0.0dBMulti
USB In 1/2
Trim
USB In 1/2
Destination
Ins/Outs
6. If necessary, move the joystick to select the Ins/Outs submenu.
7. Press PAGE > to select .