User Manual
7. Tap Tempo Button - Pressing the TAP button a few times sets
the tempo, which Delays and other FX that oer "sync-to-tempo"
can then follow. The footswitch LED ashes in time to indicate the
tempo for the current Preset (the ashing behavior can optionally be
disabled in the Firehawk Remote app).
Tuner Mode - Press and hold the TAP button for a few seconds
to enter Tuner Mode. Pluck an individual string on your guitar and
you’ll see the name of the note and its pitch in the LCD, as shown
below. When the graphic bar is to the right of center, your string is
sharp; when it is to the left, your string is at. When the bar is within
the center range, your string is in tune. Touch any footswitch or knob
to exit Tuner Mode.
A
A
A
Sharp
Flat
In tune
The Tuner Mode displayed in the LCD screen
Note: You'll also see the LEDs around the Master Volume knob light
up similarly to indicate the tuning status when in Tuner Mode.
8. Expression Pedal - The onboard Expression Pedal can be set to
two dierent Pedal Modes for each Preset: Volume/Wah Mode,
provides control of either the Volume or Wah (toggled using the
pedal's toe switch), and Tweak Mode provides control of the same
Amp or FX parameter that is assigned to the device's FX Knob. You
can optionally connect an Expression Pedal (such as a Line 6 EX-1)
to the PEDAL 2 jack on the rear panel for greater control. Note that
Pedal 2 is automatically detected when connected, and your Pedal
functions change as described in the following Conguring Pedal
Functionality section.