User Manual

The following table describes how the dierent processing Blocks are
indicated on the device while in Live Edit Mode.
BLOCK TYPE ABBREVIATION
IN LCD SCREEN
FOOTSWITCH LED
COLOR
Drives & Dynamics
DRV
Yellow
Compressor
CMP
Filters, Synths & Pitch
SYN
Purple
Modulation
MOD
Blue
Delays
DLY
Green
Reverb
REV
Orange
FX Loop
FXL
Turquoise
Looper
LPR
White
Amp
AMP
Red
Speaker Cabinet
CAB
Preset EQ
PEQ
• Select a Block to Edit: Press the footswitch assigned to the Block
that you wish to edit. You'll see the LCD rst show the full name
of the selected Block's current model, and and then display the
current model's rst parameter - now you're ready for editing.
Digital Delay
DLY:Time 430ms
First the full model name is shown, then its rst editable parameter
• To Edit the Current Parameter: Move the device's Expression
Pedal or Master Volume Knob to adjust the editable value. Or,
press the Bank Up  or Bank Down  footswitches to adjust the
value in ne increments. You'll see the parameter's current value
indicated in the LCD and by the Master Volume knob's LED ring.
• To Edit a Dierent Parameter: Repeatedly press the same
footswitch to cycle through all editable parameters for the current
model.
• You can adjust the value for one parameter, then simply tap
the footswitch again to edit another. Your edited values are
all retained until you exit Live Edit Mode, at which point you
choose to Save or discard them.
• Note that Model Select option allows you to choose a dierent
model type, which then becomes assigned to the current
footswitch.
• To Edit a Dierent Block: Press any other FS1–FS5 or A–D
footswitch to access its assigned block. You'll then be able to edit
its current model, or load a dierent model, using the same steps
mentioned above.
• To Exit Live Edit Mode: Press both the Bank Up  and
Bank Down  footswitches simultaneously.
Be sure to Save to retain your edited settings. See the previous
6. Preset & Bank Select Footswitches section for details on Save
Mode.
NOTE: The device's Tone, Reverb & FX knobs and the Tap Tempo
footswitch all continue to function while in Live Edit Mode.
Factory Reset & Pedal Calibration
Performing a Factory Reset restores the Firehawk FX to the original
factory settings and Presets. Be sure to use the Firehawk Remote app
to back up your customized Presets before performing a Factory
Reset! After performing a Factory Reset, it is recommended that you
next perform the Pedal Calibration for proper Pedal operation.
• Factory Reset: Simultaneously press and hold the Master Volume
Knob and the TAP footswitch as you power on the unit.
• Pedal Calibration: Power O your Firehawk FX device, then press
and hold footswitch A while powering On the unit. Follow the steps
in the LCD screen to calibrate the on-board Expression Pedal.