Owner's Manual

POD Farm 2 Advanced User Guide – Driver Panel & Recording
3•17
When the POD Farm 2 standalone application is not in use by the selected Line 6 device, this Input
Source menu offers a list of input options. The options will differ depending on the Line 6 device -
(POD Studio and TonePort) UX2 displays the following:
When POD Farm 2 standalone is not
running, the Input Source Select menu
is available. As shown here, UX2 offers
several input Sources to choose from.
The selected Source is what gets routed
to the Record Sends.
GX, DI and GuitarPort devices are always “xed” to only route their 1/4-inch input signals. With
one of these devices, this Input Source Select list offers only “Instrument” as the source.
POD X3 and PODxt devices are “xed” to route their input signals. With one of these devices
there is no Source Select menu displayed in the dialog.
2 – Record Sends info box: One line for each Record Send appears here along with a general
description for each Send.
POD Studio, TonePort & GuitarPort devices (except UX8) show two stereo Sends (1-2 and 3-4):
The Record Sends description shows the
Input Source, and informs you if that signal
is “processed” or not. Since POD Farm 2
standalone is not running, the signals are
unprocessed.
3 – Hardware Meters Show: For Line 6 devices that offer the on-board VU style meters (UX2, KB37
& UX8), this menu allows you to select what signal the meters measure (the selected Input, Main
Output, Record Sends Output, or ToneDirect Monitor Output).