Owner's Manual

THAT’S USING YOUR FEET: FLOOR BOARD: THE FULL-FEATURED FOOT

7 • 3

Channel Select

So, now that we’ve got this whole Bank thing down, let’s move onto the other four

switches on the bottom row. These let you pick which of the four channels – A, B,

C, or D – you want to use in the bank you’ve selected. Pick your Bank , hit

one of the Channel Select switches , and you’re ready to roll.

Manual Mode

Hey, what about Manual Mode? Don’t worry – you can get there any time. Let’s

say you have a particular Channel selected. The channel’s corresponding light is

lit above its Floor Board Channel Select switch, right? OK, step on this switch a

second time and hold it for at least a second. Boom! You'll ﬁnd yourself

transported directly to Manual Mode. The Floor Board display will show a zero. To

get back out of Manual Mode, press either Bank Up or Bank Down foot switch

and you’ll be switched right back to wherever you were when you entered.

Editing and Saving POD Channels with the Floor Board

The basic story on editing the programmable POD channels is in the POD

Effects Chapter. With a Floor Board you’ll ﬁnd that the display will show an

E (for “Edited”) whenever you’ve edited a channel. It will display an S (Save) if

you press the Save button on your POD in preparation for saving a channel. When

you decide you want to save an edited channel, you can select any of the locations

via the Floor Board as your destination. Here’s how:

1. EDIT A CHANNEL’S SETTINGS TO YOUR LIKING.

2. PRESS THE SAVE BUTTON ON YOUR POD.

3. P

ICK THE MEMORY BANK YOU WANT TO STORE TO WITH THE BANK UP AND BANK

DOWN SWITCHES ON THE FLOOR BOARD.

A.ON YOUR POD, PICK THE CHANNEL MEMORY LOCATION (A, B, C, OR D) YOU WANT

TO SAVE TO WITHIN THE SELECTED BANK, AND

5. PRESS THE SAVE BUTTON TO COMMIT YOUR MASTERPIECE TO YOUR POD’S MEMORY.

B.SKIP 4A AND 5, AND JUST KICK YOUR CHOSEN FLOOR BOARD CHANNEL SELECT

SWITCH TWICE TO SAVE INTO THAT CHANNEL.