User Manual

Press REC/ODUB to start recording your loop. You can press
REC/ODUB again to immediately end your loop and begin
recording as many overdubs as you’d like, or...
Press
PLAY/STOP to continue the loop without recording. You
can still jam over your loop. It just won’t be overdubbed into your
loop. Press again to stop the loop playback.
PLAY ONCE can be pressed from stop or during playback, to
cause play to end when the loop completes.
Hit a bad note? You can press
UNDO/REDO to discard your last
overddub. This is also handy if you just want to remove your last
overdub momentarily. Press
UNDO/REDO again to recall the
discarded overdub.
Step on
HALF SPEED while in playback mode and your loop
will now play back in half speed. Start a new loop in half speed
when you need additional loop time - up to 56 seconds.
The
REV footswitch sets your playback to reverse. Reverse can-
not be engaged during record - doing so will immediately stop
recording and start playback of your loop in reverse.
Press the
PRE/POST to route the Looper before or after the FX
Units.
Using FX while looping
Any effects you have on when entering Looper mode will remain in your
signal path. To change your FX Units or Switch Scenes during looping
press the
LOOPER CONTROLS footswitch to exit loop mode, make
your selections and then press the
LOOPER CONTROLS footswitch to
return to Loop mode. Setting your looper to “
PRE” will apply FX to your
guitar signal only. In the Setup Menu setting the looper to “
POST” will
apply FX to your loop recording and your guitar signal.
setup
Press and hold the LOOPER CONTROLS / HOLD FOR SETUP foot-
switch to enter the setup mode. Use the parameter knobs to adjust the
settings described below.
FX1:PDL2
FX3:PDL2
FX2:PDL1
FX4:OFFLPR:OFF
Expression Pedals
Version #
Expression Pedals - Each FX Unit can be controlled by one of the
expression pedals, or none. A pedal can control more than one FX Unit.
Set pedal to heel and make desired setting, then set pedal to toe and
make desired setting, then pedal between them.
The number displayed at top row, left is your stompbox modeler’s soft-
ware version. Use Line 6 Monkey software to check for updates.
PLAY
OVERDUB LO CUT120 BPM
LprLvl LprEQTempo
HI CUT
Tempo - Your lower left knob sets the global tempo of all time/speed
based effects.
LprLvl - Play (upper middle knob) adjusts the overall playback level of
the looper. Overdub (lower middle) adjusts the level of each overdub
pass from 0dB to -20dB.
LprEq -Hi Cut (upper right) adjusts the frequency of a Lo-pass filter. Lo
Cut (lower right) affects the frequency of a Hi-pass filter. Both Hi Cut
and Lo Cut only affect the recorded and looped audio only.