User Manual

sCenes & sCene setup
You can run your M13 Stompbox Modeler in Scene Select Mode giving
you 12 scenes, each of which is a complete pedalboard, storing all the
settings of the A/B/C memories of the 3 FX Units. In addition to all the
FX settings, a scene stores the signal position of the send/return loop,
BPM, DSP/True bypass, Gate, plus the expression pedal assignments,
so those can change with each scene. We’ve loaded each scene with an
example pedalboard, to get you inspired.
SwampThing
AZ Still Brings It
My ScratchPad Scene
Zepplica
Call The Police
Bridge Of Vibes
On The Edge
‘Road’ Suitcase
Bass In Your Face
DL Mania
Jeff-O-MATIC
Expression Pedals!
To access your Scenes, step on the SCENES footswitch. Your displays
will now show the names of all 12 available scenes. The currently active
Scene is shown in the solid circle (
AZ Still Brings IT in the example
above) and its corresponding footswitch will be lit. To select a different
Scene, press any of the other 11 FX Unit Footswitches. Momentary
Scene Mode is the default setting, so selecting a new scene puts you
right into a whole new pedal board where you can turn effects off and on.
Momentary Scene Mode
In Momentary Scene Mode, once you select a new Scene your display
will then return to the basic operation view. You can now activate or
bypass any FX Unit if you would like. Any changes you make to the
Scene will automatically be saved, just like a traditional pedalboard
setup. To select a new Scene, simply step on the
SCENES footswitch
and choose a new scene.
Latch Scene Mode
In Latch Scene Mode, the only difference is when you access your
Scenes, the 12 Scenes remain on the display after you have loaded a
new Scene - you won’t see FX Unit settings in the LCD. Step briefly on
the SCENES footswitch to return to basic operation so you can tweak
individual effects. This mode is exceptionally handy when you want to
switch from one set of multiple effects to another. Bypass all FX units by
stepping on the active scene footswitch.
Scene Save
To save your current set of FX Units settings to a scene or to copy your
currently loaded Scene from normal operation, holding
SCENES initi-
ates scene save:
Scene names are shown in the displays, with current scene inverted and
flashing.
Press an
A/B/C footswitch to select a scene to replace, and now just that
display is lit, showing just the that scene name.
You can change the name by turning the
MODEL SELECT knob to
change the selected character. Turning the upper right parameter knob
chooses other characters for editing.
SCENES light is flashing: hold it for at least 2 seconds to complete the
save (or step on
LOOPER CONTROLS or TAP to abandon saving).
Scene Folders
Your M13 is equipped with 4 scene folders giving you a total of 48
scenes. To access a new folder press the scene button and then turn FX
Unit 1’s Model Select knob and select the folder you wish to load (1-4)
then press any scene to load it. Scenes will now default to the new folder.
LoopeR & setup
The Looper in the M13 gives you up to 28 seconds of mono recording
time at normal speed, or 56 seconds at half speed. Your loop will always
run in mono, even if you’re running stereo FX.
To enter and exit looper mode, press the Looper Controls switch.