User Manual
ReaR ConneCtions
POWER FX SEND
L(MONO) RIGHT
OUTPUT
L(MONO) RIGHT
INPUT
L(MONO) RIGHTPEDAL 2
EXPRESSION
PEDAL 1
MIDI
OUTIN L(MONO) RIGHT
FX RETURN
1 2 3 4 5 6 7 8
1. Cable Retainer - Wrap your power supply cable around this once or
twice to prevent an accidental disconnect.
2. Power Input - Connect the included Line 6 Power Supply here.
3. Power - Switch goes up, lights come on. Switch goes down, lights go off.
4. MIDI In/Out - Please see www.line6.com/manuals for the skinny on
MIDI features, which allow you to remote control scene changes, FX
unit memory selection, looper operation, expression pedals, and tap
tempo. Plus dump and receive scene data via MIDI System Exclusive
messages.
4. Expression Pedal 1 + 2 - Compatible with standard expression pedals,
including the Line 6 EX-1. Control FX parameters in real time by
assigning them to either of these expression pedal inputs. The Line 6
expression pedal is a passive 10K ohm mono linear taper pot, using a
standard 1/4 inch mono instrument cable.
6. Stereo Input - When connecting your guitar or other mono source use
the
L(MONO) input.
7. FX Loop - This loop is assignable anywhere in the chain of M13
Stompbox Modeler’s FX Units, and is ignored when a return is not
connected.
8. Stereo Output - For mono output, use the L(MONO) output.
BasiC opeRation
FX (1,2,3,4) Units - You can run up to 4 effects at once. Each FX Unit
has 3 memories (
A, B & C), which can run any model of any type
(Distortion–yellow, Delay–green, Modulation–blue, Filter–purple &
Reverb–orange. Your audio path starts with
FX Unit 1 on to FX Unit
2, 3 and last 4.
Display - Each display shows the current settings for that FX Unit. The
display illuminates the color of current effect type (Distortion–yellow,
Delay–green, Modulation–blue, Filter–purple & Reverb–orange). The
letter at the top right indicates whether the A, B or C memory is run-
ning. To the right of this is the effect model name. If no FX Units are on
the display will read “
BYPASS”. Knobs control settings as shown above.
Note: Press in the MODEL SELECT knob to change effect type or turn
the
MODEL SELECT knob to select a new model.