Quick Start Manual

1. MODEL SELECTOR - This is where you pick the model you want to use; it comes up pre-set to a great sound.
2. DRIVE - Typically sets the amount of distortion to your signal. Check the distortion model descriptions for more details.
3. BASS - Typically a bass tone control. Check the distortion model descriptions for more details.
4. MID - Typically a midrange tone control. Check the distortion model descriptions for more details.
5 TREBLE - Typically a treble tone control. Check the distortion model descriptions for more details.
6. VOLUME - This knob is always used to set the output volume of the effect. Turn counterclockwise for less output. Turn clockwise for more.
7. STOMP SWITCHES -Theseswitcheschooseoneofthe4memories.Steponaswitchtogetthesoundthatwasstoredthere.Tochangewhat’sinamemory,holdone
of these switches for 3 seconds: that will store whatever sound you are currently hearing, so you can recall it by pressing that switch.
Using the Optional Noise Gate
WhiledevelopingthemodelsforyourDistortionModeler,wethought,‘wouldn’titbecoolandoh-so-21stcenturytoaddanoisegatetotameanyannoyingsingle-coil
hum,and/orunwantednon-fuzznoise?’Sowedid,andwe’vegivenyoutheoptionofturningthenoisegateonoroffforeachofthefourpresetmemories.Followthese
steps to set the gate for each preset:
1. It’simportantyoustartfrombypassmode(alllightsmustbeOFF).Now,chooseoneofthefourpresetstompswitches,andpressandholdittoturnthepresetonand
enter the noise gate select mode.
2. WhilestillholdingdownthepresetswitchturntheVolumeknobtosetthestatusofthenoisegateonthepreset.(Above12o’clockisOn,below12o’clockisOff).
3. TheLEDofthecurrentlyselectedpresetindicatesthestatusofthenoisegate:
 •LEDlit=noisegateon
 •LEDunlit=noisegateoff
Please note that the noise gate is not available when using the JET FUZZ model.
1
2
3
4 65
7