User Manual

Power Up Procedure
Press on/off button to turn unit on. LEDs will cycle blue-red-blue on power
up sequence. Once unit is powered on the unit will display current channel
number with a blue LED and battery life with a red led.
The unit will automatically scan for your digital RF signal. This is indicated
by the blue LEDs cycling back and forth 1-5 then 5-1. After each cycle, the
unit will stop on the current red batt life LED then blink the current blue
channel LED. The unit will stay in this mode until a transmitter is turned on and transmitting on the
same channel. Once the link is established and the receiver is receiving data, the unit will display
current channel number with a blue LED and battery life with a red LED by continually toggling
between the two LEDs.
As the user inputs audio into transmitter and sends it to the receiver unit, the LEDs on the receiver
become an audio level indictor. Blue LEDs are displayed from left to right as the audio level
increases. LED #5 will light red during audio display if the unit’s input reaches a max level. After
a few seconds pause in audio input the unit switches back to channel/battery display mode.
Channel Selection
There are 5 different frequency channels which
you can choose to transmit and receive data,
they are labeled 1-5 on both transmitter and
receiver. In order to operate on any one of these
channels, you must have both the transmitter and
receiver on the same channel number. In order to
change the receive frequency, push the channel
button. The unit will then increment and display the channel number with a blue LED each time the
user presses the button down. Continue this until the desired channel number is reached. The unit
will then go back to the mode displaying battery life and channel number.
Receiver Battery Metering
the battery is displayed on the receiver as follows: LED #5(furthest to the
right looking at the front of the unit) means 5hrs or greater of batt life
remaining. As the battery expires the unit will change the red LEDs to #4
for 4hrs, #3 for 3hrs, etc.. Once the unit has less than 1hr left of battery life
the #1 LED will then blink at a high rate until the battery expires. This
alerts the user to the need of battery replacement.
Power Down Procedure
To turn the unit off press and hold the on/off switch until the LEDs flash a red/blue alternating
pattern then release the on/off button the unit will then power down. all LEDs off indicate power
down is complete.
Setting Up Your Receiver
5