User Manual

Introduction to the XDR-95 Digital UHF Wireless
Created specifically for performing and recording musicians who demand to be untethered
without compromising their sound, the XDR-95 24-bit digital wireless system delivers your
tone and performance with the sound and feel of a direct wire connection.
X2’s proprietary digital technology provides superior fidelity while the XDR-95’s receiver houses a micro-processor that selects the
digital data stream from among the four internal receivers to eliminate dropouts and interference including DTV and other digital signal
sources. You’ll enjoy the sound and performance of a direct wire connection free from compander ICs - and the associated ’pumping’
and ’breathing’ - that squash your tone, as well as other problems associated with analog wireless technology.
Operating the system is unlike any wireless you’ve tried before. Simply connect the transmitter to the source via the 1/8" threaded-collar
locking connector and the rack-mount receiver to your amplifier or mixer. Then power up making sure the transmitter and receiver are
set to the same channel. That’s it. You’re ready to go! No knobs to adjust and no antennas to loose or break mean you’re up and
running in the time it would take to connect a cable. For maximum performance range, attach the included 1/2 wave antenna or
optionally remote mount standard paddle antenna for even greater flexibility and range.
About the XDR-95 Digital Wireless System
All of this sound and performance is provided to you with an incredible feature set including:
• 24-bit digital converters yield 118 dB dynamic range to capture your most expressive performances
• Frequency Clear™ digital transmission means no FCC or DTV concerns
• Q-DiversityPLUS™ dual-frequency transmitters and receivers eliminates dropouts, multipathing and interference
• Five user-selectable channels (all five are fully compatible for simultaneous use)
• Full bandwidth frequency response 10 Hz - 20 kHz
• Balanced XLR and unbalanced 1/4” TRS outputs
• Real-time LEDs display critical performance indicators including operating channel, RF status, link status, audio level, transmitter
battery life - no menus to scroll through!
With the XDR-95 Digital UHF Wireless System you’ll have the freedom and sound to deliver your most expressive performance every
time without any hassles or complicated setup procedures.
To familiarize you with your new digital wireless system, we suggest that you read through this entire operation manual.
System Components
All system include:
• XDR4 Digital UHF receiver
• XAC4 (9V DC 500mA power supply for XDR4 - ASA120 type)
Bodypack systems include:
• XDT4 Digital UHF transmitter
• (1) 9V Alkaline Battery
• 1/4” to 1/8” locking connector instrument cable
1