Instruction Manual


)'$*!($$)#

"-B0K$#)'$!!'
$1B4AE40;;(054CHD834;8=4B34C08;43C7A>D67>DCC78B<0=D0;
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact your
!>20;!8=2>;=DC7>A8I4384;3(4AE824028;8CH for technical troubleshooting assistance before you proceed.
*)$#
%'$!"(
(."%)$"(
%$((!
*(
'$""#
$*'($)$#
Err 263 No usable weld modes. 1. The power source does not have
any welding programs loaded.
2. See the power source Instruction
Manual for load welding pro-
grams.
If all recommended possible areas of
misadjustment have been checked
and the problem persists, Contact
your local Lincoln Authorized Field
Service Facility.
'!# (.()"''$'$(
4;>F0A44AA>AB8<?;4<4=C435>AC74"-B0K
)H?820;*B4A=C4A50243868C4AA>A2>34B=>C1;8=:43>=C74BC0CDB!
AA>A
>34
N/A
28
83
84
(>DA24
User Interface
Feeder
Feeder
Feeder
*)4GC
" Limits Exceed "
"Gear Box Type"
“OUTPUT DISABLED”
" UI Shutdown 1 "
" UI Shutdown 2 "
'40B>=
When a mode is selected with a work point low limit
greater than the high WFS limit. (no event is logged)
The shutdown 2 input on the Feeder Board is open and
P.21 is selected for “Output Disable”
The shutdown 1 input on the Feeder Board is open.
The shutdown 2 input on the Feeder Board is open.
AA>A
>34
213
215
247
274
275
276
277
278
281
282
(>DA24
User Interface
*)4GC
Power Source
is Off-Line
Feeder Board is Off-Line
N/A
N/A
N/A
N/A
N/A
N/A
(Varies based on the
error type and who
caused the error)
(Varies based on the
error type and who
caused the error)
'40B>=
User Interface could not communicate with control board
in power source.
Either no feed head board is connected, being repro-
grammed or experiencing a fatal event.
Arc control has a latched fault. The UI will indicate a
Reset button needs to be pressed to clear the fault.
Weld set change required clearing of user memory.
UI memory could not be saved. Contact Lincoln Electric
Service Department for further support.
UI memory could not be restored. Contact Lincoln
Electric Service Department for further support.
UI memories were converted due to change in number of
UI parameters. Info only.
UI limits were converted due to change in number of UI
parameters with limits. Info only.
Internal Error. Collect all displayed values and contact
Lincoln Electric Service Department.
Internal Error. Collect all displayed values and contact
Lincoln Electric Service Department.