Instruction Manual


$%')$#

"-B0K$#)'$!!'
%0A0<4C4A 458=8C8>=
% "4<>AH70=64!>2:>DC
Determines if the memories can be overwritten with new contents.
#> = Memories can be saved and limits can be configured (default).
.4B = Memories cannot be changed - saving is prohibited and limits cannot be re-configured.
This parameter can only be accessed using Power Wave Manager software.
% "4<>AHDCC>=8B01;4
Disables the specified memory button(s). When a memory is disabled, welding procedures can-
not be restored from or saved to that memory. If an attempt is made to save or restore a dis-
abled memory, a message will be displayed on the lower display indicating the memory number
is disabled. In multi-head systems, this parameter disables the same memory buttons on both
feed heads. This parameter can only be accessed using Power Wave Manager software.
% ">34(4;42C%0=4;!>2:
Selects between several Mode Select Panel lockout preferences. When a Mode Select Panel
selection is locked and an attempt is made to change that parameter, a message will be dis-
played on the lower display indicating the parameter is locked.
;; "(% $?C8>=B *=;>2:43 = All adjustable parameters on the Mode Select Panel are
unlocked.
;;"(%$?C8>=B!>2:43= All knobs and buttons on the Mode Select Panel are locked.
(C0AC=3$?C8>=B!>2:43 = The Start and End parameters on the Mode Select Panel are
locked, all others are unlocked.
,4;3">34$?C8>=!>2:43 = The weld mode cannot be changed from the Mode Select Panel,
all others Mode Select Panel settings are unlocked.
,0E4>=CA>;$?C8>=B!>2:43 = The Wave Control parameters on the Mode Select Panel are
locked, all others are unlocked.
(C0AC =3 ,0E4 $?C8>=B !>2:43 = The Start, End and Wave Control parameters on the
Mode.
Select Panel are locked, all others are unlocked.
(C0AC=3">34$?C8>=B!>2:43 = The Start, End and Weld Mode Select parameters on the
Mode. Select Panel are locked, all others are unlocked.
This parameter can only be accessed using Power Wave Manager software.
% (4CD?"4=D!>2:
Determines if the setup parameters can be modified by the operator without entering a pass-
code.
#> = The operator can change any set menu parameter without first entering the passcode
even if the passcode is non-zero (default).
.4B = The operator must enter the passcode (if the passcode is non-zero) in order to change
any setup menu parameters.
This parameter can only be accessed using Power Wave Manager software.
*('#%'")'($#)