Instruction Manual
$%')$#
The Setup Menu provides access for configuring user preferences, which are generally only set at installation.
The user preferences are grouped as shown in the following table.
"-B0K$#)'$!!'
()*%"#*)*'(
((#)()*%"#*
((
To access the Setup Menu, Press the Left Button and
Right Button simultaneously. The Setup Menu
Indicator will light and the lower display will read as
shown below.
Note: The Setup Menu cannot be accessed during
welding, or if a fault is displayed. To resume welding,
exit the Setup Menu.
%''#(!)$#
Scroll through the Preference list by rotating the
Control Knob. Press the Right Button to edit the select-
ed preference.
%''##
Scroll through the preference options by rotating the
Control Knob. Change the preference setting by press-
ing the Right Button. To cancel, press the Left Button.
-)
To exit the Setup Menu, press both buttons simultane-
ously or select P.0 and press the Left Button. Sixty
seconds of inactivity will automatically exit the Setup
Menu.
#>C4 If a product is missing any of the preference
options listed below, a software update may be needed
from www.powerwavesoftware.com.
*'()*%"#*
P. 0
Exit
User Prefs
Setup Menu
Indicator
Mode Select
Panel (MSP)
Left Button
Control Knob
Right Button
%'")'
% through %
% through %
% through %
#)$#
Unsecured Parameters (always adjustable)
Diagnostic Parameters (always read only)
Secured Parameters (only accessible with Weld Manager)