Product Manual

ASSEMBLING THE SAW
The Boom sections must be joined before mounting LIMBSAW to your vehicle.
Remove the two (2) bolts from the end of the LIMBSAW Arm assembly with a 9/16" wrench. Rotate
and stand the Arm assembly onto the Arm Angle bracket, with hydraulic hoses toward you, as
shown. Place Boom Arm Bottom at the end of the Arm assembly, hose exit flange toward you.
Insert hydraulic hoses into swedge end of Boom Arm Bottom and out
through exit flange. See pictures left and below. Slide sections together
while pulling the slack from the hydraulic hoses.
Reinsert the two (2) bolts and tighten with
9/16" wrench to secure.
Use a ½" wrench to loosen the hydraulic
hose clamp, insert hoses, then retighten.
&YJU'MBOHF
Remove bolts
before assembly
9
YOUR SHIPPED CONTAINER SHOULD INCLUDE
t a receiver pinned to the end of the 4' Boom Arm Bottom
t a folded mast section with chainsaw and hydraulic lines
The packet contains:
t 4 nuts and bolts, for attaching the receiver to
your loader
t a 3/16" allen wrench for adjusting chain oiler
t a brochure
t a warranty registration card
t THIS Installation & Operation Manual, that
you should read completely before you begin
installation and operation
"SN"OHMF#SBDLFU
&YJU'MBOHF
3FDFJWFS
)ZESBVMJD)PTF$MBNQ