Product Manual

MOUNTING THE SAW
Before mounting the LIMBSAW into the receiver, rotate your bucket
so the receiver is positioned as shown. Your saw weighs about
86 lbs, making it easy to mount. Lift the saw and insert the end
into the receiver until it hits the stop. Pin and clip to secure.
The saw can be easily removed and stored when not in use.
Because every tractor has
its hydraulic hookups in
a different location, your
LIMBSAW does not include
the hydraulic lines that attach to the vehicle. You will need to
purchase these lines with a minimum of ⅜" hydraulic hose.
Measure from the auxiliary hookups of your vehicle to the
hydraulic hookups on your saw. Allow enough slack in your lines
for the full rotation of your
bucket.
The bottom right picture shows the saw in the Travel position.
When driving to and from your work site, always keep the saw
folded and pinned to protect it from the wear and tear that
bouncing can cause. Always be aware of power lines and other
hazards that may be hanging in your path.
Travel Position
10
INSTALLING THE RECEIVER
Install the receiver to the back of your loader, at the top, on
the right side.
Positioning it at the top of the bucket, as shown in this
picture, will afford you an extra two feet of reach when
operating your saw.
When installing the receiver with the bolts, use a ½"
drill bit. Receiver can also be welded in place. Loaders
which have rolled or folded lips may require a spacer
to achieve proper alignment. Check alignment before
proceeding with installation.
Bolted on
Welded on
4QBDFS