Use Instructions

12 13
4.3 Cleaning
Before first use
Elvie Stride is not provided sterile. It must be cleaned and
sanitized before first use. Always disassemble the
components before cleaning or sanitizing. For additional
cleaning guidelines see the Center for Disease Control
website – https://www.cdc.gov/healthywater/hygiene/
healthychildcare/infantfeeding/breastpump.html
1. Before first use, remove the Cup Seal by peeling it out
of the groove on the side. During normal cleaning this
Cup Seal can stay in place
2. To replace, stretch the Cup Seal over the outer rim of
the Cup Front. Make sure it goes on with the ridges
facing outwards. Press along the groove, checking
that it is snugly in place all the way around
Non-washable components
The Hub, Cap, Tubes, Tube Splitter, Cover and Clip are
non-washable components and should be kept dry.
They must not be microwaved. They can be wiped clean
with a damp cloth, but should not be submerged in water.
If the tubes are moldy, discard and replace immediately.
Washable components
Cleaning washable components that come into contact
with milk, as soon as possible after pumping, prevents the
buildup of dry milk residue. Residue can cause the growth
of bacteria that may be harmful to you and your baby.
Breast Shield
Stopper
Cup Front
Diaphragm
Valve
Cup Seal
Cleaning (before first use and after every use)
1. Rinse in cold, clear water. Do not place the parts
directly in the kitchen sink for rinsing and washing.
Use a dedicated wash basin and brush for infant feeding
2. Wash in warm water using mild dish washing soap
3. Rinse with cold, clear water for 10 to 15 seconds
Place on the top shelf of the dishwasher
OR
Charging Port Hub
Tube Splitter
ClipCover
Long Tube (for the Hub)
Short Tube
(for the Cups)
Charging Cable
Hub Connector
Cap Seal
Tube Splitter
Stopper
Cap