Use Instructions
16 17
4.5 Assembling Elvie Stride
Wash hands thoroughly before you begin. Once the parts
have been cleaned and sanitized, make sure they are dry
and not moldy before putting them together. Pay extra
attention to the Diaphragm and ensure it is completely dry.
1. Attach the Cover and Clip. Slide the Hub into the
Cover, ensuring the hole for the Hub Connector is
aligned with the hole on the Cover. Push the short
end of the Clip through the slot, and pull through
3. Push the Valve and Diaphragm
onto the Breast Shield
4. Use your fingers to work the Diaphragm rim over
the Breast Shield lip. Take a moment to check the
Diaphragm is sitting flush and is on securely
Diaphragm rimBreast Shield lip
5. Push the Breast Shield and the Cup Front together
using the markings as a guide. Ensure that there is a
good seal all the way around. Check that there are
no gaps and that the Cup Seal is fully covered by the
frosted lip of the Breast Shield
Tip: Take the Cup Front o and check that the Dia-
phragm is on correctly if:
• You can’t get the Cup to push together fully
• You can see the Cup Seal above the frosted lip
6. Check that the Diaphragm is completely dry because
moisture can be sucked into the Hub. This will aect
performance. Push the Cap into the Cup Front
Frosted lip
2. Push the Hub Connector firmly into the Hub,
ensuring that it is fully inserted