User manual

Bachmann Europe Plc
8 H0 1:87
Fig. 5
Front light system
The railcar was normally used on its own. However, one or other goods trucks was added
on secondary routes. To enable you to also depict the model in this scenario, the front or
rear light can be set depending on the version used. The integrated multiswitch (S) can be
located by removing the cover plate (A) on the underside of the rail car as shown in Fig. 6.
Please pay attention to the circuit diagram for the switch in Fig. 5. The model comes with
the light change white/red in both directions.
Switch
position
1 2 3
ON
4
Light change white/red depending on the direction of travel
1 2 3
ON
4
Only light on the end of car 2, with light change white/red
1 2 3
ON
4
Only light on the end of car 1, with light change white/red
1 2 3
ON
4
Light change white depending on the direction of travel
1 2 3
ON
4
Interior lighting off

1 2

Fig. 4
X
G2
G
2
Y1
Y3
4
G
Z