User manual

Bachmann Europe Plc
10 H0 1:87
Changing the motor
First remove the top circuit board (M1) as
shown in Fig. 8, it is fitted with two screws
to the interior. You can now gently remove
the plugs (M2). In order to be able to re-
move the bogie from below, loosen the two
screws (M3) and remove the retaining lid
(M4). You can now unclip the motor bracket
(M5) on the individual bogies and removed
the motor (M6). Refitting is effected by follo-
wing the sequence in reverse.
If you have decided on a LILIPUT model for
the three rail AC system, please observe the
following:
This model has a digital decoder installed
(ESU Lokpilot) which can be used to power
your vehicle either on an analogue basis
(16 Volt AC) or digitally. Please consult the
instruction sheet supplied by ESU for details
on how the decoder works. For power pick
up from the central rail, the slider has to be
clipped on to the bogie with the aid of a hol-
der (AC1) as shown in Fig. 9. To change the
slider, please slightly press apart the retai-
ning arms (AC2) of the holder using a small
screwdriver. This enables the retaining seat
of the central slider to be removed from the
holder R.
M1
M3
M2
M5
M6
M2
M4
Fig. 8
Your model as an AC variant
Fig. 9
AC1
AC2
LILIPUT hopes that your railcar model will give you a lot of pleasure.
R