User manual

Bachmann Europe Plc
10 H0 1:87
Loco sound system
The loco comes prepared for sound system installation. The installation of the 16 mm speaker requires
the removal of the loco body from the chassis (see ”Removing the loco body”). The boiler backplate
KR (Fig. 5) serves as the speaker securing point. Undo both screws S3 and clip the speaker into place
with the diaphragm facing outwards.
The sound decoder can be plugged vertically into the 21-pole digital interface PL in place of the
bridging plug JP or in place of another decoder. Two connection pins SPK on the circuit board provide
the electrical link for the speaker.
It is essential to follow exactly the instructions supplied by the manufacturer of the decoder and the
speaker. Please note that we can accept no liability in respect of any speaker subsequently installed in
the model.
If you have the AC version of the model...
Please see the following important notes for LILIPUT model operation on the stud contact AC system:
This model is fitted with a decoder (type ESU-LokPilot V 4.0) which allows either analogue 16 volt AC
or digital operation. The mode of operation of the decoder is explained in the accompanying manual
provided by the supplier, ESU.
The stud contact electrical pick up skate is clipped to the chassis by means of support HA, as shown
in Fig. 7. To change the skate, move the securing arms A of support HA laterally slightly outwards with
a small screwdriver. This releases the support and the skate can then be removed.
Fig. 7
HA
HA
A
A
LILIPUT thanks you for purchasing this model
and hopes it brings you a lot of pleasure.