User's Manual

Lilee Systems™ TransAir™ PTC-3000 Family User Manual
Page 22
4.1.9 TNC to TNC Cable for Syncing PTC-3000 Units
Step 1: Locate the 1pps TNC connectors. The location of the 1pps TNC connectors is shown
above in Figure 1 and Figure 2.
Step 2: Insert the TNC cable. Insert one end of the TNC connector into the 1pps TNC
connector of one PTC-3000.
Step 3: Secure the TNC cable. Turn the locking cover of the TNC connector end of the TNC
connector clockwise to secure connector on the PTC-3000.
Step 4: Connect to second PTC-3000. Repeat Steps 2 and 3 to connect to the TNC cable to
the 1pps connector on the second PTC-3000.
4.1.10 Power Cable and Power Adapter
When other cable connections are complete, connect the PTC-3000 to a power source
according to the following steps.
Step 1: Locate the power connector. Please see Figure 1 and Figure 2 to locate the power
connector on the PTC-3000.
Step 2: Insert the 3-pin terminal block to +19 V power cable or M12 to +19 V power cable.
Insert the 3-pin terminal block end or M12 end of the power cable into the 3-pin terminal
block power connector or M12 connector on the PTC-3000.
Step 3: Insert the +19 V end of the power cable to the power adapter.
Step 4: Connect the power cord to the power adapter.
Step 5: Connect the power cord to the power outlet.
Step 0:
4.2 USB Flash Disk Removal and Installation
4.2.1 Remove SIM/USB/Reset Panel Cover
Step 1: Locate Cover. Locate the SIM/USB/Reset button panel cover on the front panel of the
PTC-3000.
Step 2: Unfasten Screws. Using a screwdriver, unfasten the screws by turning
counterclockwise.
Step 3: Remove Cover.