Instructions

Steady green: Status normal
Flashing green: Transming
Flashing green / amber: Linking mode
Steady red: Cannot contact server
Seng up the Link Plus
2.1 Aach the Ethernet cable
Take the Ethernet cable (supplied) and connect it to
any spare available LAN port on your wireless router.
Connect the other end of the cable to the Lightwave
Link Plus’ single port.
2
2.2 Aach the power supply
Plug in the power supply and push the Micro USB
connector into the socket on the back of the Link Plus.
The Link Plus will now enter its startup sequence and
will aempt to nd a connecon to the Lightwave
server. A solid amber light indicates that a connecon is
being aempted, and a solid green light will show once
a connecon has been established. Once the green
light appears, the Link Plus is ready to be set up on the
Lightwave Link Plus App.
2.3 Check the indicator light
The LED indicator is used to indicate the status of the
Link Plus and also to indicate if there is a problem. If
there is a problem reported, it will usually refer to an
insecure cable connecon or a server connecon
problem (see list on the right). If the Link Plus has already
been set up, the App will display details of any specic
problem; otherwise, please visit the support secon at
www.lightwaverf.com for advice.
LED Indicator lights
www.lightwaverf.com
Need some help?
[e-mail]