Guide

LightWare Studio parameters screen
Serial port baud rate
Controls the baud rate used by the serial UART interface in kbps.
(The baud rate should be as high as possible to accommodate high measurement update rates.)
Startup mode
Determines the communication behavior of the LW24/C when turned on.
Update rate
The number of measurements per second. From 48 Hz to 388 Hz.
Zero distance offset
An offset applied to the measured distance value.
Lost signal threshold
The number of failed measurements before a loss of signal is reported.
Enable median filter
The median filter is used to disregard short unwanted measurements.
Median filter size
Determines response time of median filter.
Enable rolling average filter
The rolling average filter averages over a specified number of distance measurements.
Rolling average size
The number of distance measurements to use for the rolling average filter.
LW24/C/RS microLiDAR™ sensor - Product guide | Version 0 | 03 March 2022 Page 16 of 38