User's Manual

38
1. Overview 2. Installation
3. Optional
Accessories
4. Troubleshooting
5. Warranty, Safety
& Specifications
1. Screw the bracket to a place high
on the wall or in the middle of the
solid ceiling. Mount the bracket
horizontally as shown above.
2. Uncoil the Cat 5 sensor cable.
Connect one end of the cable to
the ISR. Route the wire back to the
TOPCAT system, securing it along
with way using surface raceway
where possible.
3. Slide the ISR onto the bracket until
it “clicks” into place.
a. Guide the mounting rails
onto the bracket, oriented as
pictured.
b. Once secure, the ISR locks into
place.
c. To remove the ISR, slide a
ruler or screwdriver behind the
ISR to press the release bar
down and slide the ISR off the
bracket
4. Remove the metal cover (move
over to cover the other hole
or discard if electrical power is
installed) over the 1 inch dia. round
hole of the TOPCAT back can to
pass the cable into the TOPCAT.
IR SENSOR/RECEIVER (ISR) INSTALLATION
CONT’D
Wall/Solid Ceiling Mount
5. Open the TOPCAT front panel
door. Find where the previous
CAT 5 cable was connected and
plug in the new CAT 5 cable.
6. Secure the CAT 5 cable using
cable ties such that the cable is
not touching the chassis or able
to vibrate against the sides of the
unit.
7. Close the TOPCAT access door.