User's Manual

30
1. Overview 2. Installation
3. Optional
Accessories
4. Troubleshooting
5. Warranty, Safety
& Specifications
REDMIKE SHARE: INITIAL SET-UP
1. Ensure the TOPCAT is ON. The
blue LED on the Media Connector
will glow.
2. Turn on the REDMIKE Share
by sliding the switch to the top
position.
3. Grip the barrel in the center
section. Avoid covering the
infrared emitters just below the
microphone grille. This could
interrupt signal transmission.
4. While speaking in a normal voice,
increase the CH. B VOLUME on
the TOPCAT level until your voice
is barely audible.
OPTIONAL PAGEFIRST INTERFACE
This optional feature interfaces with an independent classroom paging system.
When the page is broadcast, all audio from the system is muted, ensuring
important and even emergency school-wide messages are never missed.
REMEMBER: This equipment is designed to supplement and distribute the user’s
voice so they are able to speak in a conversational tone. Having the volume set
too high will result in feedback and listener fatigue.
(For full installation details refer to the install sheet included with the optional
PageFirst sensor clip)
How it works:
1. PageFirst sensor clip is hung
around the lead wires attached
to the classroom paging
speaker.
2. The clip is hard-wired to the
TOPCAT.
3. As a page is broadcast, the
sensor clip detects the audio
signal through induction and
immediately mutes the TOPCAT.
4. When the page is over, the audio
from the TOPCAT returns to
normal volume level.
Paging
Input
Microphone
Volume
Registration
AB
Aux Po
w
DC: 24V
/
Adj.