User's Manual

22
1. Overview 2. Installation
3. Optional
Accessories
4. Troubleshooting
5. Warranty, Safety
& Specifications
11. CHARGING THE REDMIKE VC
Before use, the REDMIKE VC should be charged. It will take 8-9 hours for the
REDMIKE VC to obtain a full charge. A fully charged REDMIKE VC will last for
over 7 hours of use. If microphones are used daily, they should be kept in the
cradle – microphones can be left in a charging cradle constantly for up to 2
weeks without causing degradation to battery life.
A red light on the charging cradle indicates the REDMIKE VC is charging.
A green light indicates that charging is complete and a full charge has
been reached. A blinking light indicates a charging or sensing error. See
Troubleshooting section for more information.
REDMIKE VC incorporates alkaline protection into the microphone design.
Always use a Lightspeed rechargeable sensing battery. Replacement AA NiMH
batteries may only be purchased through Lightspeed Technologies (part # BA-
NH2A27). Do not attempt to charge alkaline batteries. They can overheat and
expand creating a significant hazard and damaging the microphone (this is not
covered by warranty).
1. Plug power cord into the cradle
charger and then plug the AC end
into an electrical outlet.
2. Ensure that the REDMIKE VC is
turned OFF.
3. Place the REDMIKE VC into the
cradle. The LED on the cradle
will glow RED indicating charging
has started. When the REDMIKE
VC is fully charged the LED on
the cradle charger will change to
GREEN.