User's Manual

12
1. Overview
2. Set Up & Use /
Daily Operation
3. Optional Accessories
4. Maintenance &
Troubleshooting
5. Warranty, Safety
& Specifications
1B. TO SET-UP MOUNTED ON A WALL CONT’D
1. Level template and tape to wall
2. Mark position of drill holes on wall
3. Drill pilot holes
4. Insert anchors
5. Remove feet from Redcat Access and place over anchors
6. Insert and secure screws through the Redcat Access feet into the
anchors
7. If using optional security bracket, mount on wall using the
provided screws and anchors
8. Slide the Redcat Access onto the wall mounted feet
Drill Template
for wall-mounting the REDCAT System
Drill holes
Instructions
Determine the best location for the REDCAT,
refer to the user manual provided with this
product. For wall mounting, the REDCAT
should be mounted 7 to 8 feet from the floor.
1. Start by leveling this template and taping
to the desired location on the wall.
2. Mark the hole locations using a sharp
pencil. (7 locations)
3. Drill pilot holes
4. Insert anchors
5. Insert screws through the feet and tighten
to the wall
6. Insert screws through the security tab
bracket and tighten to the wall.
7. Slide the REDCAT onto its mounted feet.
If the safety tab is installed, it should snap
into place preventing system removal.
Materials Required
Drill Bit: Size appropriate for the
anchors or screws being used.
Anchors: Needed for mounting
on drywall, plasterboard, or
cement block.
Screws: Wood screws or screws
appropriate for anchors.
Security Tab
Foot Foot
IG0432US01-0
AC-IGRC2DT
OR