User's Manual

28
1. Overview 2. Daily Operation
3. Optional
Accessories
4. Troubleshooting
5. Warranty, Safety
& Specifications
CERTIFICATIONS
This product conforms with the essential requirements of
the following European Union Directives: 2004/108/EC
Electromagnetic Compatibility (EMC) and 2006/95/EC Low
Voltage Directive (LVD).
USE A LIGHTSPEED
SUPPLIED BATTERY ONLY
Lightspeed Technologies launched a formal product recycle
program in Europe that complies with the European Union
Directive 2002/96/EC on Waste Electrical and Electronic
Equipment (“WEEE Directive”). Please visit our website at
www.Lightspeed-tek.com for contact information.
This product is manufactured using lead-free processes and is
free of other materials harmful to the environment. It conforms
to the most stringent new European guidelines for consumer
products (RoHS).
This product is listed to UL standards and requirements for
electrical safety by Underwriters Laboratories Inc.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate this equipment.
This equipment has been tested and found to comply with the limits of a Class B Digital Device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction may cause harmful interference to radio communication. However, there is no
guarantee that interference will not occur in a particular installation.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
Caution: To maintain the compliance with the FCC’s RF exposure guideline, place Media Connector & Topcat at
least 20 cm from nearby persons.
!
SAFETY WARNINGS AND CERTIFICATIONS
CAUTION
RISK OF ELECTRICAL SHOCK
DO NOT OPEN