User's Manual

5. OPERATING THE FLEXMIKE
Once the Flexmike is charged, follow these steps to set it up for use.
1. Turn the Redcat Access power
switch to the on position.
2. Remove the Flexmike from the
charging cable and put it on by
connecting the magnetic clasps
behing your neck. The Flexmike
will automatically power on when
it is left in the on position while
charging.
3. The microphone volume on the
Flexmike is set at the factory to the
mid point.
4. While speaking in a normal voice,
fine-tune the volume up or down.
Proper volume level should be as
follows:
• Yourvoiceshouldbeclearly
heard by another person on the
other side of the room.
• Youshouldbarelybeableto
hear your own voice.
• Thereshouldnotbeanyaudio
“feedback” or squealing
outside of 2-3 feet (if there is,
turn the volume down slightly).
REMEMBER: This equipment
supplements the user’s voice so they
are able to speak in a conversational
tone. Having the volume set too high
will result in feedback and listener
fatigue.
6. Once initial volume level is set,
walk around the room and listen
for overall audio quality.
7. If further fine-tuning is required,
you may need to adjust the Tone
Control on the top of the RCA.