User's Manual

1. Overview

2. Set Up & Use /

Daily Operation

3. Optional Accessories

4. Maintenance &

Troubleshooting

5. Warranty, Safety

& Speciﬁcations

2A. CONNECT ACCESS LINK TO AMPLIFIER

STANDARD UNBALANCED CONNECTION

1. Plug one end of the included 3.5mm cable into the AUDIO OUTPUT

connection on the Access Link.

2. Plug the other end into a microphone or audio input connection on an

ampliﬁer.

NOTE: depending on the type of input jack on the ampliﬁer, an adapter or

other audio cable with matching plug may be required (not included).

3. Set the MIC/LINE level switch in the appropriate position. Generally LINE

level is used unless the ampliﬁer input is speciﬁcatlly market as a “Microphone

Input.”

BALANCED CONNECTION FOR LONGER CABLE RUNS

In the event the Access Link must be located more than 12feet away from the

ampliﬁer, it is recommended to use the balanced audio output on the Access

Link. To ensure a fully balanced connection, there must be a true balanced input

on the ampliﬁer and balanced audio cable must be used.

1. Connect the stripped wires into the marked openings on the euro-block

connector:

A. Insert the positive and negative signal wires to the marked terminals.

B. Insert the shield to the ground terminal.

4. Secure the inserted wires by tightening the retaining screws.

5. Connect the other end of the cabling to a balanced input on the existing

ampliﬁer.