User's Manual

29
1. Overview 2. Initial Set-up 3. DaiIy Operation
4. Additional
Information
5. Maintenance &
Troubleshooting
6. Safety &
Specifications
SECTION 5:
MAINTENANCE &
TROUBLESHOOTING
REGISTRATION OF REPLACEMENT OR
ADDITIONAL EQUIPMENT
In order for all system components to operate and communicate with one
another, they must be registered to the base station. When purchased as a
complete system, all components will be pre-registered and ready for use, so
there is no need to manually register anything.
In the event a component needs to be replaced or an additional component is
purchased down the road, it will need to be registered following the step by step
instructions below.
• Start with all FLEXCAT system
components powered down (in
the charger or switched OFF).
• Turn on the Base Station.
• Remove the Belt-Pack(s) from
the charger and ensure they are
powered on.
• Remove each group speaker
from the charger and ensure
they are powered on.
• Wait for the “Ready” signal from
all components as indicated by
the following:
– The Belt-Pack(s) will have
a solid blue Teacher 1/2
LED lighted.
– The green “Ready” LED on
the bottom of each speaker
will be lighted.
– Press the ALL key on a
Remote. The Base Station
LINK LEDs will light for each
speaker and each Belt-Pack
that is already registered.
– The link light for the speaker
you are adding should not be
lit.
• Proceed to the instructions for
the appropriate component
POWER
REGISTER
SPEAKERS
LINK
REMOTES
REGISTER
MULTIPACKS
REGISTER LINK
ON
VOL
ON
REG
LINK
REGISTER
STATION
#
OFF
POWER
READY