User's Manual

ManualsBrandsLightspeed Technologies ManualsElectronicsFlexcat Pod

1. Overview 2. Initial Set-up 3. DaiIy Operation

4. Additional

Information

5. Maintenance &

Troubleshooting

6. Safety &

Speciﬁcations

Function Command Description

Whole Class

Instruction

Press center

button

Activates Redcat Access speaker to

distribute teachers voice to the entire

class.

Small Group

Instruction

Press #1-6 Activates a 2-way audio connection to

a small group. The teacher can address

and listen to that group simultaneously.

Small Group

Monitoring

Press MUTE, then

#1-6

Mutes the teacher microphone while

listening in on group conversations. The

pod # button will turn red.

Student Group

Sharing

Press and hold

#1-6

Allows one student group to address the

whole class. Both the center and pod #

buttons will light.

Disconnect Press activated

pod # again

Disconnects the transmission and turns

any audio off. The pod # button will go

dark.

Teacher earbud

volume

Press Vol UP/

DOWN arrows.

Turns the volume to the teacher's earbud

up or down. There is an audible tone in

the ear when pressing.

Using the remote:

4. Pod call button:

• Each of the pods is equipped with a call button students can press

when they need assistance.

• When the button is pressed, a tone sounds in the teacher earbud.

• The corresponding pod # will blink on the remote, alerting the teacher

which group needs assistance.

• The light will continue to blink until the teacher selects that pod.

• To clear multiple blinking lights: press center button twice (connect

and disconnect from whole class mode).

5. Return the components to the charging station for nightly recharging:

• For convenience, we recommend leaving the pods powered on. They

are designed to charge normally in the ON position.

• Place all components in their respective charging slots:

– Pods: insert with charging contacts facing down.

– Flexmike(s): use corresponding mic 1 or 2 center charging slot.

– Remote(s): use corresponding mic 1 or 2 outside charging slot.

• Charging lights will light - red = charging; green = fully charged.

• The units will fully charge overnight.

NOTE: the blue link lights on the Flexmike(s) and pods will stay on to

indicate the microphone number (1 or 2) and that they are ready for

operation.

DAILY OPERATION CON’T

Vol

Mute