User's Manual

40
1. Overview 2. Initial Set-up 3. DaiIy Operation
4. Additional
Information
5. Maintenance &
Troubleshooting
6. Safety &
Specifications
PROBLEM: Remote does not light or
activate any group speakers
SOLUTION:
• Ensurethebatterieshaveacharge.
They should be charged nightly.
• TrypressingtheMUTEbutton.
– If this button lights, the remote
has a battery charge.
– If this button doesn’t light, the
battery is dead.
• Ensurethebasestationispowered
on.
• Ensureatleastonegroupspeaker
and at least one belt-pack are
“READY” for operation.
– Once verified, try pressing the
ALL button on the remote. This
will activate any speaker and
any microphone that is linked
up.
• Ifusingateamteaching
configuration, ensure you are using
the correct remote with the correct
belt-pack (Teacher 1 with Teacher
1)
– Try using the second remote to
verify.
– If you are still unsure, open
the remote’s battery door and
observe the position of the
Teacher 1/Teacher 2 switch.
• Itispossibletheremoteisnot
properly registered to work with
the base station. Please refer
to the registration process to
reconnect.
PROBLEM: Belt-pack does not
indicate a “READY” signal
SOLUTION:
• Ensurethebatterieshaveacharge.
They should be charged nightly.
• Ensurethepowerswitchisturned
on. Once turned on, the LED
should begin blinking.
• Ensurethebasestationisturned
on. If the base station is power off,
the belt-pack has nothing to link
to.
• Powertheunitoff,thenonagain
after a few seconds. Wait for up
to 30 seconds for the blue LED to
turn solid, indicating READY for
operation.
• IfnoREADYsignalisindicated,
it is possible the belt-pack is not
properly registered to work with
the base station. Please refer
to the registration process to
reconnect.
TROUBLESHOOTING CONT’D