Instructions / Assembly

pg.2
USER SERVICING INSTRUCTIONS
To replace the fuse:
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
2. Open fuse cover. Slide open fuse access cover on top of attachment plug towards blades.
3. Remove fuse carefully. Turn fuseholder over to remove fuse.
4. RISK OF FIRE. Replace fuse only with 3 Amp, 125Volt fuse (provided with product.)
5. Close fuse cover. Slide closed the fuse access cover on top of attachment plug.
6. RISK OF FIRE. Do not replace attachment plug. Contains a safety device (fuse) that should not be removed.
Discard product if the attachment plug is damaged.
CLIPS ASSEMBLY INSTRUCTIONS
1. Assemble the light hook parts A & B as shown in illustration 1
2. Push the A and B parts together until you feel a click, and the clamp portion is securely fitted on the stem.
3. Install on gutters or under shingles (shown in illustrations 3 & 4). The angle of the clip is adjustable simply by bending it.
4. Use the built-in holes if the hook is to be installed on a wall or flat surface using nails or screws(illustration 5).
WARNING
The product is to hang up and use, and leaking hole is down direction.
CAUTION
This string is rated 1MAX. 8Watts ( 0.15Amps ),
do
not overload.Connect other Lighting Strings or decorative outfits end-
to-end
tup o a maximum of 210 Watts (1.75Amps) total.
If connecting to a lighting string that does not have a wattage (W) rating (found on the tag within 6 inches of the plug),
Calculate The wattage (W) as follows: Multiply the current (0.15A) which is on the flag type tag Within 6 inches of the plug,
by 120.
For example, string is rated 120V, 60Hz, 0.15Amps, 0.15×120=18 Watts.
Add the wattage of each light string together for a total of 210 Watts or less. (Do not exceed 210 Watts)
Total amount of wattage that can be connected 210W-18W=192W.
CAUTION
To reduce the risk of fire or electric shock, do not attempt to replace lamps or modify string.
FOR INDOOR AND OUTDOOR USE
NOTE: This item is not a toy and should be used for decorative purposes only.
WARNING
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
illustration 1
illustration 2
illustration 3
illustration 4 illustration 5
Nails and/or screws are not included.