Instructions / Assembly

E-2
CAUTION: To reduce the risk of fire and electric shock:
1. Do not install on trees having needles, leaves or branch coverings of metal or materials which look like metal.
2. Do not mount or support wires in a manner that can cut or damage wire insulation.
SAVE THESE INSTRUCTIONS.
ASSEMBLY INSTRUCTIONS
1. Gently remove contents from packaging and lay out in a clear
area.
2. Push A through the circle, insert the grooves of Projection™, and
tighten the circle, then adjust the angle of Projection™
(See illustration 1) and tighten screw B.
3. Insert desired image slide to the card slot(See Illustration 2).
4. When the border effect is not clear, adjust the focal length. By turning dial on the front of
the Projection™.
5. Unplug when not in use.
USER SERVICING INSTRUCTIONS
Fuse Replacement (Fuse: 2pcs)
WARNING: Risk of Fire: Replace only with same size and type of fuse.
WARNING: Risk of Fire: Do not replace the attachment plug. Contains a
safety device (fuse) that should not be removed. Discard product
if attachment plug is damaged.
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on the cord.
2. Open fuse cover. Slide open the fuse access cover on top of the attachment plug towards blades. (See illustration)
3. Remove fuses carefully.
4. Replace fuse only with 5 Amp Max, 125 Volt fuse (provided with product)
5. Close the fuse cover. Slide closed the fuse access cover on top of the attachment plug.
OPERATING INFORMATION
This product was designed for indoor and outdoor use.
Do not shake the device. Avoid brute force when operating the device.
Keep away from direct and excessive heat sources.
Do not permit operation by unqualified persons. Damages are usually the result of unprofessional operation.
Never use solvents or aggressive detergents in order to clean the device. Rather use a soft and damp cloth.
illustration 3
Working
Fuse
Replace
Fuse
illustration 1 illustration 2