User manual

41
4º-Select an empty Playback where the Cue is going to be stored.
LightShark will assign to it the next available Cuelist ID, generating a new
Cue, with the next available Cue ID.
5º-Press “CLEAR” to empty the programmer.
6º-To confirm that everything has been successfully recorded, activate
the Playback.
2-Recording on a Playback which already has some information in it
1º-Select a fixture (or group of fixtures).
2º-Modify at least one of its parameters (or press “FIND” to activate all
the parameters).
3º-Press the “RECORD” key (it will light up).
4º-Select the desired Playback. The Cue will be stored at the end of the
Cuelist with the next Cue ID available from the main list.
5º-Repeat steps 1 to 4 as many times as neccesary.
6º-Press “CLEAR” to empty the programmer.
7º-To confirm that everything has been successfully recorded, activate
the Playback.
Modifying Cues
The EDIT command can be used to load the information of a Cue into the programmer.
Once the changes are done, press UPDATE to save them in the original Cue.
Erase a Cue
When the user needs to erase a Cue that is already recorded:
1º-Go to the Cuelist window and select the Cuelist that includes the
desired Cue.
2º-Press DEL and then tap on the ID number of the Cue to erase.
Copy a Cue
It is possible to copy a Cue from one Cuelist to another:
1º-Go to the Cuelist window and select the Cuelist that includes the desired
Cue.
2º-Press COPY and select the final Cuelist.