Installation Instructions

2322
Complete the Installation
1. With the Connec tor at tached to the low-voltage wires, position
the Controller’s stake where it will be installed. Loosely guide
the top of the Controller with the palm of your hand. Use your
foot to push down the spike and drive it into the ground.
Note: Do NOT pull on the Controller while pushing the spike
down, as this may damage the unit.
2. Once the Controller is in place, the Connector can be set tled
above or below ground.
Reconnect the Transformer
2. If necessary, turn/select OFF any photo-sensors or timers that
would interfere with the wireless controller.
1. Turn the power ON at the circuit breaker or fuse,
and/or plug-in your transformer, and turn it ON.
Note: It is important the transformer remains ON continuously,
and does NOT automatically shut o. Insure that your
transformer is set to Manual ON, or Continuous ON.