Installation Instructions

1716
Install the Connector
2. Locate the low-voltage wire that runs between your transformer
and the rst of the landscape lights. Choose a place along the
wire in the lawn or landscaping, where the Controller’s stake can
be inser ted into the ground. Here, the Connector will attach to
the low-voltage wire.
1. Unplug / disconnect your Low-Voltage Transformer
4. Remove the 2 caps from the top of the Controller’s connector.
Pull up on the tabs to relase the caps.
Note: the caps are designed to t one-way on the connec tor,
and won’t t if their direction are reversed.
3. Unear th this por tion of the low-voltage wire. Make sure there’s
enough slack to easily cut and manipulate the wire. Then use
wire-cutters to cut the wire here.
We recommend that you turn OFF power at the circuit breaker or
fuse, and test that the power is OFF before proceeding.