User Manual

Juno 2 / Juno 4
User manual
Thank you for purchasing the Lightpro Juno.
This document contains the required information for
correct, efficient and safe use of the product. Consult
the general manual of the Lightpro 12-volt system
and the user manual of your transformer for more
information about the set up and connection of your
light plan.
Read the information in this manual carefully before
using the product. Keep this manual near the product
for consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Juno is a standing LED lamp for outdoor
use. The fixture can be mounted on a solid surface
or placed in the ground with the supplied spikes.
This product may only be used as outdoor lighting
in combination with the Lightpro 12-volt system.
Any alterations made to the product may have
consequences for the safety, guarantee and correct
functioning of the product and/or other parts of the
system.
SPECIFICATIONS
Product Lightpro Juno 2 / 4
Article number 193S / 194S
Light source LED 2 / 4 W AC/DC 12V
Power (max) 2 / 4 W
Luminous flux (max) 192 / 372 lm
Light colour 3.000K
Average lifetime 25.000
Dimensions (h x Ø) 85 x 55 x 68 mm
Protection class IP65
Ambient temperature -20°C to 50°C
Cable length 2m
Dimmable No
Light source Not replaceable
On/off 10.000
INSTALLATION
Packaging content
[Figure A]
1. Fixture Juno
2. Baseplate
3. Screw
4. Screw
5. Spike
6. Screws
7. Plugs
8. Lightpro connector
9. Hex key
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: [e-mail]
Option 1: Placement on a fixed underground
[Figure B]
Mount the base [2] on the surface with the included
screw [6].
If necessary, drill a holes in the underground and use
the included plug [7].
[Figure D]
1. Attach the fixture [1] to the foot [2] with the screw [3].
2. Set the fixture to the desired position.
3. Fasten the screw [3] using the included hex key [9].
[Figure F]
Ready
Option 2: Placement in the ground
[Figure C]
Mount the base [2] on the spike [5] with the included
screw [4].
[Figure E]
1. Attach the fixture [1] to the base [2] with the screw [3].
2. Set the fixture to the desired position.
3. Fasten the screw [3] using the included hex key [9].
[Figure G]
Place the fixture in the ground.